Knowledge base 208: How to tell the difference between the KP800 Models
There are two different models of the KP800 that have different programming procedures.
The new model with a curved peak on the black facia and terminal wiring block connectors.
The older model with a high peak on the black facia with a pigtail wiring connectors.
The Manuals are attached to this article
Related Articles
Knowledge base 228: Using MorphoManager with Grosvenor
Requirements: Advance Controller (SNG (1 Blade) or MLT(4 Blades)) with 2 Door Blade, max 2 readers / 2 Door Blade. An IDEMIA Sigma Lite, Sigma Lite Plus, Sigma Wide, MorphoWave XP, VisionPass or VisionPass SP. A MorphoManager Up to 10, Up to 25, Up ...Knowledge Base 230: Ordering replacement Master Card for Standalone Products
This knowledge base article explains the process required for ordering a replacement Master Card for the Controlsoft All-In-One and Solo range of Standalone products. The Master Card is programmed with the device's serial number. You can find this on ...Knowledge base 197: MSO 300 / MSO1300 drivers
This Knowledge Base explains how to Update the drivers of an Idemia MSO 300 / MSO 1300. An internet connection is required to download the driver files Admin rights will also be required 1. With the MSO USB device connected to the PC, right-click on ...Knowledge base 220: Identity Access Pre-Installation Checks
To ensure that your software installs correctly, it is important to run through the following pre-installation checks. 1. Temporarily disable your antivirus for the duration of the installation. Due to the amount of Anti-Virus packages, we cannot ...Knowledge base 207: Identity Access Removed or Lost without backups
If the PC holding Identity Access software has failed and no external backup is available, then a reinstallation and recommission of the system will be required. A site survey may be required to ensure the system is setup as it was previously. Some ...