Knowledge base 146: Morpho Readers basic setup with Identity Access V8

• Related Articles

• Knowledge base 186: IDEMIA Morpho Readers with Identity Access 9

  This document will cover how to set up an IDEMIA biometric reader using direct integration in Identity Access. Requirements An IDEMIA Biometric reader (Sigma Wide, Sigma Lite, Sigma Lite + or Sigma Extreme) PC running Identity Access (IA) with a ...

• Knowledge base 178: Identity Access 9 - Sigma series reader with an LCD display for Pin & Biometric

  This KB explains how to create a custom Biometric profile for a Sigma Series reader (LED Model required) for Pin & Bio using Identity Access version 9. This KB is based on the Biometric reader being wired into an i-Net Plus V3 door controller and ...

• Knowledge base 90: Using MorphoManager BioBridge & Identity Access 8

  1.    First install Identity Access (IA), follow the Installation Guide available with the download or IA USB Stick. 2.    Next log into Identity Access to do this run the IA User Interface – Windows Start Button > All Programs/All Apps> Controlsoft ...

• Knowledge base 200: IPv4 error when adding IDEMIA readers into Identity access using a hostname

  An IPv4 error will be shown under the Morpho reader settings when a customer attempts to add an IDEMIA reader using the readers hostname instead of an IPV4 address. The error is shown below and can only be resolved by entering an IP V4 address -

• Knowledge base 201: Moving Identity Access

  1. Checking your Identity Access License To check whether the current installation is licensed login to Identity Access and go to Home > About. 2a. If the system shows a Professional License or Enterprise License and Version 9.XXX.XX, the license can ...