Knowledge base 171: MorphoManager communication ports

• Related Articles

• Knowledge base 89: Using MorphoManager BioBridge with Paxton

  Introduction BioBridge is an enrollment and synchronization middleware that overlays enrollment and demographic synchronization between MorphoManager and third-party data sources. The infrastructure is extensible and supports interfacing to multiple ...

• Knowledge base 169: Setting up MorphoManager with Sigma series readers in Biometric only mode

  This bulletin explains how to install and configure MorphoManager with Sigma series readers for either Standalone mode or ACU mode (for use with access control systems). Equipment required - 1. PC/Server running the following spec - Processor: Dual ...

• Knowledge base 179: Identity Access 9 MorphoManager BioBridge Guide

  The following guide explains how to configure the link between Identity Access version 9 and MorphoManager BioBridge for enrolling biometrics. For a guide on installing Identity Access click here For a guide on installing MorphoManager click here ...

• Knowledge base 228: Using MorphoManager with Grosvenor

  Requirements: Advance Controller (SNG (1 Blade) or MLT(4 Blades)) with 2 Door Blade, max 2 readers / 2 Door Blade. An IDEMIA Sigma Lite, Sigma Lite Plus, Sigma Wide, MorphoWave XP, VisionPass or VisionPass SP. A MorphoManager Up to 10, Up to 25, Up ...

• Knowledge base 102: MorphoManager with MA Sigma iClass series – HID iClass (Standard 26bit) + Biometrics

  It is possible in MorphoManager to set up the MA Sigma/ Sigma Lite Series readers in a Biometric + HID iClass mode. This bulletin will explain how to configure the system where a user must present a card & their biometric before being allowed access. ...