Knowledge base 86: Using Morpho Readers as Standalone Readers
When using Morpho readers such as the J-Series,
Sigma, Sigma Lite or Sigma Lite Plus in standalone mode to control a door, we
recommend using a timer relay between the reader and the lock. This makes the system more resilient and
protects the Fingerprint readers on board relay
If using a J-Series reader, use terminal blocks RL1 (Relay
COM) and RL2 (Relay NO)Related Articles
Knowledge base 186: IDEMIA Morpho Readers with Identity Access 9
This document will cover how to set up an IDEMIA biometric reader using direct integration in Identity Access. Requirements An IDEMIA Biometric reader (Sigma Wide, Sigma Lite, Sigma Lite + or Sigma Extreme) PC running Identity Access (IA) with a ...Knowledge base 133: Identity Access 8 - Time & Attendance with a standalone Sigma / Sigma Lite + reader
This requires an IA-PRO license if you do not have an IA-PRO license please contact sales@controlsoft.com The following knowledge base describes how to configure Identity Access to work with a standalone MA Sigma/ Sigma Lite + Series reader to allow ...Knowledge base 2: Using HID Readers on Metal Surface
When mounting HID iClass/Multiclass SE readers, it is strongly recommended that they are NOT mounted onto metal surfaces, as this greatly affects the performance of the reader. In some instances, performance can be affected if the reader is within ...Knowledge base 198: Sigma Lite Plus - Sand timer & Police officer icon shown on screen.
Problem - A customer is reporting this image is showing on the LCD screen of the Sigma Lite reader - Solution - The green LED of the Sigma Lite reader (17 - LED OUT 1) is not connected to the iNets Wiegand green LED input and the customer are using ...Knowledge base 200: IPv4 error when adding IDEMIA readers into Identity access using a hostname
An IPv4 error will be shown under the Morpho reader settings when a customer attempts to add an IDEMIA reader using the readers hostname instead of an IPV4 address. The error is shown below and can only be resolved by entering an IP V4 address -