This knowledge base article explains the process required for ordering a replacement Master Card for the Controlsoft All-In-One and Solo range of Standalone products. The Master Card is programmed with the device's serial number. You can find this on ...
There are two different models of the KP800 that have different programming procedures. The new model with a curved peak on the black facia and terminal wiring block connectors. The older model with a high peak on the black facia with a pigtail ...
Question: What card formats can I use with the AC-3300 (solo2)? Answer: The AC-3300 (solo2) simply reads a 26-bit number and stores it in its memory. When reading a card to open a door, it compares the 26-bits read in against the 26-bit numbers ...
The below diagram shows how to wire in 2 standalone controllers to one mag lock, this is shown using an AC-3100 but applies to any of the standalone lines.
A KP800 can have the Master code reset by powering down the unit, pressing the # key and powering up until the unit gives a long beep and the right hand side Green LED is lit. The master code is then set to 1234 To enter programming mode press - ...